欢迎访问《生物质化学工程》,

生物质化学工程 ›› 2018, Vol. 52 ›› Issue (2): 18-22.doi: 10.3969/j.issn.1673-5854.2018.02.004

• 研究报告 • 上一篇    下一篇

豌豆淀粉/聚乳酸双层膜的制备与性能表征

周晓明, 盛杰, 刘旭, 杨仁党   

  1. 华南理工大学 制浆造纸工程国家重点实验室, 广东 广州 510640
  • 收稿日期:2017-09-21 出版日期:2018-03-30 发布日期:2018-04-03
  • 通讯作者: 杨仁党(1967-),男,教授,博士生导师,研究领域:植物资源综合利用新技术;E-mail:rendangyang@163.com。 E-mail:rendangyang@163.com
  • 作者简介:周晓明(1993-),男,湖北赤壁人,硕士生,主要研究方向:造纸化学品、可降解材料;E-mail:454695873@qq.com
  • 基金资助:
    制浆造纸工程学科引智基地(2015B020241001);浙江省农产品化学与生物加工技术重点实验室浙江省农业生物资源生化制造协同创新中心开放基金(2016KF0201);中央高校基本科研业务费专项资金资助(x2qs-D2171020)

Preparation and Characterization of Pea Starch/Polylactic Acid Double Layer Film

ZHOU Xiaoming, SHENG Jie, LIU Xu, YANG Rendang   

  1. South China University of Technology, State Key Laboratory of Pulp and Paper Engineering, Guangzhou 510640, China
  • Received:2017-09-21 Online:2018-03-30 Published:2018-04-03

摘要: 采用溶液流延法以豌豆淀粉(PS)和聚乳酸(PLA)为原料制备了豌豆淀粉/聚乳酸(PS/PLA)双层薄膜。通过对双层薄膜的吸水性、溶解性、水蒸气透过性、拉伸性能、表面形貌等进行测试,研究了薄膜的力学性能、疏水性能以及水蒸气阻隔性能。结果表明:随着双层膜中聚乳酸层的比例增加,双层薄膜的吸水性、溶解性和水蒸气透过性逐渐降低,拉伸强度和拉伸模量逐渐增加,断裂伸长率逐渐下降,表明水蒸气阻隔效果明显,增加了膜的韧性,降低了膜的强度。当PLA和PS的质量比为50:50时,PS/PLA双层膜的拉伸强度为(13.47±0.75)MPa,拉伸模量为(0.848±0.002)GPa;断裂伸长率为(16.11±0.16)%,水蒸气透过系数为0.27×10-10 g·cm/(cm2·s·Pa)。

关键词: 流延法, 双层薄膜, 聚乳酸, 豌豆淀粉

Abstract: The pea starch/polylactic acid(PS/PLA) double layer film was prepared by solution casting method with pea starch(PS) and polylactic acid(PLA) as raw materials. The mechanical properties, hydrophobicity and water vapor barrier properties of the films were studied by testing the water absorption, solubility, water vapor transmission performance, tensile properties and surface morphology of double layer films. The results showed that with the increase of the proportion of polylactic acid layer, the water absorption, solubility and water vapor permeability of double layer film decreased, the tensile strength and tensile modulus increased, the elongation decreased gradually, which indicated that the water vapor barrier effect was obvious, the toughness increased and the strength reduced. When the mass ratio of PLA and PS was 50:50, the tensile strength, tensile modulus, elongation at break of PS/PLA double layer were (13.47±0.75)MPa, (0.848±0.002)GPa, and (16.11±0.16)%, respectively; and the water vapor transmission coefficient was 0.27×10-10 g·cm/(cm2·s·Pa).

Key words: casting method, double layer film, polylactic acid, pea starch

中图分类号: